发电机检测程序.doc

发 电 机 检 测 程 序 2014.6.20 建造厂 生 产 设 计 Class 工程编号 编 绘 校 对 发电机组检测程序 Mooring Test Procedure of G/E 比例 重量 标 检 共 9 页 第 1 页 审 核 版本 审 定 日 期 2012-10-30 主要参数 main particular Type of engine：MHI S12R-MPTA柴油机型号 Output of engine: 1190KW@1800rpm 柴油机额定功率: Type of generator : STAMFORD PM734C2发电机型号 Output of generator:1120 kWe@1800 rpm 发电机输出功率 Rated voltage: 3x440V额定电压 Rated frequency: 60 HZ额定频率 number of diesel generator sets：2 sets柴油机发电机组数量 Tests and measurements before starting柴油发电机组起动前的试验和测量。 The installation of all system for generator sets to be completed. 为柴油发电机组服务的所有系统的安装工作完成。 Fuel piping燃油管路 Check the MDO service tank is ready to use, check the MDO piping system according to diagram of MDO system 检查柴油日用柜是否具备使用功能，然后按机舱燃油供给系统原理图检查燃油系统。 Lub. Oil piping 滑油管系 Before the first starting, check the Lub. Oil piping system according to diagram of lub. Oil system and service engineer’ guidance and the cleaning of sump is confirmed. 起动前按 滑油系统原理图检查管路系统，在服务工程师的指导下，检查油底壳的清洁并加油，使油位位于高，低位报警间。 2.1.3 Cooling fresh water circuit冷却水管系 a. Before filling fresh water, check the system according to cooling fresh water system 在加水之前，按 冷却管系图检查管路系统。 b. Check the cleaning of pipeline, after confirmation, fill fresh water and dose. 检查管路系统的清洁，确认淡水和药剂。 c. Degas the whole piping system 对整个冷却水管系进行除气。 compressed air system and exhaust gas system 空气起动系统和排气系统 Check the compressed air system and exhaust gas system according to relative system drawing. 按系统图对这两系统进行检查。 Starting air pipes shall be blew out, and regulate the starting air reducing valves. 起动空气管路吹气，调整起动空气减压阀。The following items should be checked. Visual inspection of generator MSB, Stability of earthing, Exactness of connection. 检查发电机和主配电板的外观,接地的牢固性,接线的正确性。 Check the function of interlocking device for turning bar. 盘车机构联锁装置的功能试验合格。 Generator’s insulation resistant in cold condition should be measured. 测量发电机冷态绝缘电阻； Before and after the