STANDARD COMMISSIONING PROCEDURE FOR （标准调试程序）.pdfVIP

STANDARD COMMISSIONING PROCEDURE FOR VARIABLE FREQUENCY MOTOR DRIVES BUILDING NAME: APPLICATION #: BUILDING ADDRESS: NAME FIRM OF PERSON(S) DOING TEST: DATE(S) OF TEST: General Notes: 1. This is a generic test procedure for variable frequency drives (VFDs). If the complexity, configuration, or other aspects of a specific project require substitute tests or additional tests, explain on the comments sheets, and attach the additional test procedures and field data. Attach all relevant functional performance verification sheets, and always attach the final signed and dated procedure certification page. 2. In all test sections, circle or otherwise highlight any responses that indicate deficiencies (i.e. responses that don’t meet the criteria for acceptance). Acceptance requires correction and retest of all deficiencies, as defined in each test section under “Criteria for Acceptance” or “Acceptance”. Attach all retest data sheets. Complete the Deficiency Report Form for all deficiencies. 3. This Commissioning Procedure does not address fire and life safety or basic equipment safety controls. 4. To ensure that this Commissioning Procedure will not damage any equipment or affect any equipment warranties, have the equipment manufacturer’s representative review all test procedures prior to execution. NAMEPLATE DATA (from equipment nameplates, as recorded in field): Criteria for Acceptance: Nameplate data must be in accordance with approved submittals. DESCRIPTION DRIVE # (Pump or Fan Symbol) Serves what equipment (describe)? Drive Manufacturer Drive Model # Drive Serial # Motor Manufacturer Motor Model # Motor Rated Horsepower Motor Rated Voltage / Phase Motor Rated Full Load Amp