Sierra Technical Manual Page 1 sierrasteels（1 sierrasteels塞拉技术手册页面）.pdfVIP

Sierra Technical ManualPage 1 Table of Contents Set up for Session Series 1 Set up for Royalty and Crown Series 1 Breakdown: 1 Electric circuit pickup - removal and replacement: 1 Pickups 2 Pickup removal replacement 2 Tuning 2 Tuning pedals knee levers 2 Half stops 2 Changer 3 To tune 3 Change-lok 3 Leverage Selection 4 Theory 4 Procedure for selection 4 Making Changes 5 Bell crank relocation: 5 Bell crank addition and re-assembly: 5 Tuning new changes: 5 Knee levers 6 Trouble shooting 6 Pedal travel (Figure 15) 6 Tension springs 6 Untrue return 6 Insufficient travel 6 Excessive travel 7 Slippage 7 Lubrication 7 Strings 7 Adjustments 7 Pedal rods 7 Mobile knee levers (Figure 8 9) 7 Page 2Sierra Technical Manual Set up for Session Series From the in-case position, Figure 20 Figure 22, insert the legs into the leg sockets and tighten the leg lock handle. The small pin on the leg stub must be in line with the slot of the leg socket. Insert the stub until the leg is even with the guitar body, then rotate the leg 90 degrees 10 be square with the body and the front legs pedal rack mounting pins facing the from, and the back legs height adjustment facing the back. Install the pedal rack by sliding the lock plates to the outside of the leg slots and position the rack on the legs so that the pins on the legs are inserted into the pedal rack. Then slide the locks in place and tighten the knobs. The pedal rods are numbered with number 1 at the string tuning end of the guitar. Install the hook end of the rod on the cross shaft arm in either hole (The hole closest to the shaft will provide the shortest pedal action