SAP2000 (version 9) University of Central Florida（SAP2000(版本9)佛罗里达中央大学）.pdfVIP

University of Central Florida Department of Civil and Environmental Engineering A Brief Overview and Tutorial SAP2000 (version 9) Prepared for Structural Engineering Track Course Instructor: Dr. F. Necati Catbas Assistant Professor Prepared By : Jason Burkett Graduate Assistant Spring 2005 SAP2000 Tutorial CES 4101 Structural Analysis II CEE-UCF Problem # 1 (Example 5.7, pg 219 of Textbook) Determine the joint displacements, member end forces, and support reactions for the beam shown in fig 5.18 (a), using the matrix stiffness method. Fig 5.18 Solution: General Procedure for using SAP2000 Nonlinear Phase I) Pre-processing Phase II) Analysis 2/9 SAP2000 Tutorial CES 4101 Structural Analysis II CEE-UCF Phase III) Post-processing Phase I) Pre-processing Opening the Program o From Start menu All Programs SAP2000 9 SAP2000 Setting up the model Geometry o File New Model Select Units: KN, m, C Grid Only o New Coord/Grid System Edit Grid o Delete all cell data for X,Y, and Z Data Define Ordinates for each axis respectively [X Grid Data: 0,6,10,15,20], [Y Grid Data: 0], [Z Grid Data: 0] ß You may also select the option to define Grid Spacing ß Note: Z-axis is in the upward direction by default in SAP2000 o Work from a 3D view to start so that you do not draw members out of plane o Draw Draw frame/cable/tendon (Select blue line on left toolbar) ß Move cursor over predefined grid and left click to draw elements 3/9 SAP2000 Tutorial