Installation Guide Decra（安装指南Decra）.pdfVIP

Installation Guide General Instructions Starter/Eave Failure to use these guidelines may void the product warranty. Local Use the Shingle Starter Clip w/ Drip Edge along the eave and paint the building codes may require additional application techniques beyond Drip Edge before installing. Prior to fastening the Shingle Starter, cut the these instructions. In such cases, the local codes must be followed. top clip where it meets the rake/gable, valley, and roof-to-wall to allow for Note: Do not use lead or copper with this steel roofing system. installation of the channels and valley. Cut back top clip approximately Do not use pressure treated lumber (i.e. decking or battens). 3” for Shingle Rake/Gable Channel Shingle Roof-to-Wall. For Shingle Valley, cut back clip enough to accommodate Shingle Valley. All channels Safety and valleys must be installed over the Starter Clip and extend 1” over Adhere to safe roofing practices, wear appropriate clothing, use safety the fascia. Notch and overlap Starter pieces 1” when joining two pieces equipment, such as protective eyewear and light, soft-soled shoes. Use together. Fasteners should be spaced 6” on center. proper tools and keep the roof clear of debris. Tools 1 2 DECRA panels may be cut using a circular saw or tin/aviation snips. An impact drill will provide for easier panel installation.