rose ha安装（Rose HA安装）.docVIP

rose ha安装（Rose HA安装） Installation environment: Two servers (the following are called server 1 and server 2), a set of disk counters, SQL Server Database software, ROSE HA Software。 Installation process: 1. Install WINDOWS 2000 (1) install all the drivers and configure the network. (2) install Services Pack 2 or higher. (3) cabinet will view the disk in the disk management two NT servers in the database to install the volume of the letter is the same, the letter must be the same. 2, installation SQL Server data base (1) turn off server 2 and install on server 1 SQL Server Database, select the program file installed in the local hard disk, the database file installed on the disk array cabinets. Installed, in the control panel services SQL Server All services are stopped and set to manual startup mode. (2) turn off server 1 and install on server 2 as described above SQL Server Data base. (3) open two servers after installation. On server 2 SQL Server The service starts, then all stops, and then the server 1 SQL Server The service starts and then all stops. Verify that these services can be started. If start and stop is normal, proceed to the following steps. Otherwise, you need to resume normal before you can do the next step. 3, installation configuration ROSE HA Software (1) hardware installation use ROSE The RS232 serial port of the software connects the server 1 and the COM1 port of server 2 Note: it is recommended to use two heartbeats, if you want to establish second heart jumpers through the network card, you can use the following methods to connect. 1. connect a private network card on a two server directly with a network cable. 2. connect the public network card on the two server via HUB. If there is only one network card on the server, you need to bind one IP address on the network card for the connection of the heart jumper. (two) software installation Special note: before you install ROSEHA, you must declare the system as the correct system date. 1. enter t