索具使用（Rigging）.docVIP

索具使用（Rigging） 14.8.1 storage Sling and rigging idle storage, the corresponding protection measures should be, not rust, corrosion or other harmful effects of high temperature and humidity. Protective measures should meet the following requirements: A. easy corrosion of mechanical parts, such as piston rod exposed parts should be yellow with glycerin coated with wrap rags and other items; B., part of the bearing, rotary rocking pin should be filled with grease; C. chain, wire rope slings should be cleaned and dried and then rub grease; D. fiber slings should be stored in ventilated and dry away from heat, and non corrosive chemicals places; E. not heavy pressure in the sling and rigging; F. shall not be under transverse load spreader, when directly placed will produce lateral load or deformation, should be placed in special hanger frame; G. should grab is in open state, claws or blade should be in contact with the ground pad of rubber plate or lumber. 14.8.2 maintenance 14.8.2.1 maintenance work by professional personnel to undertake. The technical performance of 14.8.2.2 maintenance and replacement parts shall keep the original parts. 14.8.2.3 sling is in working condition, should not for maintenance, repair or manual lubrication. 14.8.2.4 maintenance, the general should be removed from the sling hoisting machinery, because conditions are not removed, should take the following measures: A. should be a reliable protection measures or set up monitoring personnel; All the B. controller in the zero; C. cut off the main power supply, and hang (not power) obvious signs or dedicated guardian. 14.9 check 14.9.1 initial check The use of units for the new purchase, homemade or repair the sling and rigging before use, should check the full-time staff according to the standard of the corresponding provisions, determine whether they can put into use. 14.9.2 regular inspection The sling and rigging regularly by the daily use of personnel (including before use, the use of intermit