实用问题解答二（Practical question two）.docVIP

实用问题解答二（Practical question two） Practical questions two Release date: 2008-8-26 17:35:59 Q: Recently, I found that my air compressor output in water is relatively high, mainly in the air duct, air tank before the NL module (NL module function is to filter out the compressed air in the water or oil) can be discharged more water, I suspect that the water or water condenser is the problem, compressed air and water due to the high, do not know whether to seek answers. Master, the cause of the water, how to solve? This is not the cause of the frequent air compressor unloading? Thank you! Answer: you have not check the condensate emissions of air compressor, if discharged less water are needed to clean the trap. The compressed air after cooling, a considerable part of the water release in the water separator. The drainage system can discharge, if the trap fails, there will be water into the system. The filter (usually referred to the NL module you should also belong to the same type of liquid water) is difficult to deal with, resulting in a lot of water is discharged. You can use the energy drain valve installed in the module of Ingersoll Rand, in order to reduce the working pressure of the module. Q: will the pneumatic plastic head piston air outlet is what role. Whether from the mouth to add hydraulic oil lubrication? The piston and the hydraulic oil can work normally, but has no effect on equipment! Answer: you mean the adjusting cylinder? If we discuss. Just as the plastic head cover to prevent dust from entering the hole, and return with gas. Add lubricant to the effect is not great. Q: I, a twin screw compressor in loading, loading valve driving cylinder piston, and not always appear on load performance for butterfly valve drive cylinder piston action, but the stroke, the intake valve opens only about 20~10 degrees. I do not know why, please master answer or phone! Answer: this situation is complex, check the loading process, there is no open cylinder to the longest