华硕电脑卸图解.doc

【1】先看下笔记本具体型号，对号入座，不过不同型号也差不了多少 【2】准备工作要做好，主要是拆机工具（小号的十字、平口螺丝刀），安放螺丝的小盒子 【3】来个后盖的全貌 【4】拆硬盘【5】拆内存条【6】拆光驱(忘拍照了） 【7】后盖全部可见螺丝全部拆下（最好按实际位置摆放，免得最后对不上号了，有些螺丝大小还是不一样的） 【8】拆键盘F1、F5、F10、delete按键上方各有一个卡扣，稍用力向里按卡扣即可打开。取下键盘是小心，后面有键盘线连接，拔开黑色卡扣可取下键盘连接线。右上方为BIOS电池，中间靠下为触摸板连接线，与键盘连接线同样方法取下。 【9】拆下白色金属板上全部可见螺丝钉 【10】分离整机机壳。卡位比较紧，只要全部螺丝都去除了，可稍微用力拆解。 【11】BIOS电池，如果单换电池的话，到此即可。如果清理灰尘，继续向下【12】拆除左上角与右上角显示屏与底壳螺丝，拆除主板正面、风扇壳可见螺丝【13】取下主板，拆开风扇盒清扫扇叶，此处小心，别像我把扇叶刷折了一根 【14】清扫其他灰尘较多的地方，然后原路返回安装螺丝。 【15】启动系统，熟悉的logo回来了，bios菜单也能进了。后面就是系统安装界面。系统安装完毕，又可以High起来喽  manufacturers of technical documents on the quality requirements applicable to this project. Construction quality inspection and evaluation standards issued by the national power company of the electric power construction standard for quality inspection and assessment of the 11 articles assessment inspection standards as well as other relevant regulations issued by the Ministry of electric power, the State power company executive. Does not verify in the specification within the evaluation criteria, implementation design, manufacturer or ... Or issue a new national standards and regulations, bidders shall comply with new norms and standards. If there are conflicts or is inconsistent, whichever is the higher standards. 3.3 3.3.1 project of responsibility, authority and communication organization and project managers, at all levels of responsibility and authority see section II of chapter III of the present tender site management organization and part of workforce planning. 3.3.2 according ISO 9001, GB/T 50430 and company quality distribution of the quality manual, combining the departments of projects, project quality function distribution allocation table on the following page of the projects quality functions shown below. 3.3.3 project with each Department interface, interface between the internal departments of the project by project managers at all levels and the quality regulations of the responsibilities and auth