Excel中单元格的操作doc.docVIP

目录 目录 1 快速删除空行 2 快速删除工作表中的空行 2 复制或移动单元格 2 制作个性单元格 2 绘制斜线单元格 3 绘制斜线表头 3 快速修改单元格式次序 4 完全删除Excel中的单元格 4 如何合并两个有内容的单元格 4 在同一单元格内连续输入多个测试值 5 在单元格中输入0值 6 快速进行单元格之间的切换 6 取消单元格链接 7 选定超级链接文本 7 对不同类型的单元格定义不同的输入法 7 输入人名时使用“分散对齐” 8 隐藏单元格中的所有值 8 彻底隐藏单元格 8 同时在多个单元格中输入相同内容 9 快速在多个单元格中输入相同公式 9 在Excel中快速编辑单元格 9 快速格式化Excel单元格 9 快速复制单元格内容 9 将复制的单元格安全地插入到现有单元格之间 9 快速输入日期和时间 10 Excel单元格换行的几种方法 10 如何在Excel单元格中调整行距 11 Excel中完美冻结第一行、第一列的技巧 第一步：在Excel中，单击选中“B2”单击格，执行“窗口”→“拆分”命令(如图1),接下来便会出现图2所示的效果，如果没有出现图2所示效果则说明窗口拆分未成功。 　　第二步：单击选中最左上角的“A1”单元格，执行“窗口”→“冻结窗格”命令(如图3)。 　　这时就完美的实现了冻结第一行、第一列的效果了(如图4)。对于一些数据较多的表格，需要固定表头或者第一列，冻结后查看就方便多了。 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawing