机房验收明细清单.doc

FORM 820 GENERIC TEST ACCEPTANCE CHECKLIST Site: BVAPP: Engineer: Job Vendor: Date of Installation completion: Date of Vendor Departure: Tested by: Date: ITEM YES NO Equipment Verification Frames located per floor plan Installed per drawings Equipment is what was ordered Equipment options are correct Spare equipment provided per ordering spec (if applicable) Power feed to equipment checked Workmanship Frame alignment and equipment mounting Relay rack numbering Wiring and cabling Equipment numbering and lettering Cable openings sealed Cable racks and other ironwork Power and fusing (spare fuses available also) Performance Tests Tests per recommended equipment manual Tests per Test Acceptance package sent out with job (contact the Engineer if no such package sent) Documentation As-built drawings sent back to engineering Replacement drawings Initial battery charge reports (if applicable) Equipment manuals received Original test results retained Alarms Affected alarms tested prior to work start Local and audible alarms (as applicable) tested prior to work start Remote alarms installed and tested with NROC Alarm Center (800-713-3666) Name of NROC Center Contact with whom alarms were tested: Other Comments (all No answers must be commented on) FORM 821A POWER ROOM LIGHTING TEST ACCEPTANCE CHECKLIST Site: BVAPP: Engineer: Job Vendor: Date of Installation completion: Date of Vendor Departure: Tested by: Date: ITEM YES NO 1. Lighting provided in the power areas is adequate, and located in accordance with the SITE: record lighting plan drawing 2. As a minimum, emergency and task/stumble lighting is available in stairwells, over the power board, over the engine control panel and AC transfer switch, over the AC switchgear, and in the engine room 3. Emergency and task/stumble lighting works 4. Feeding fuse/breaker positions and emergency and task/stumble lighting f