ps模式（PS mode）.docVIP

ps模式（PS mode） Normal (normal mode): Use the mode to copy the source layer or channel to the target layer without mixing the source, layer, or channel in the operation or apply image, That is to replace the target completely with the source. 2--Dissolve (dissolved mode): It takes the dissolved opacity as the percentage of pixels from the blend color, and mixes the color on the base color in this proportion. (Note: the primary color is the color or image that is placed before it is mixed. The blend color is a color or image that is dissolved on the base color or on an image.) Using this model, it is the whole pixel from the image or the other one, do not see what mixed signs, if you want to reach between two images do not see signs of the mixing effect, and can have more control than the use of patterns can be dissolved in the top model. The layer built on a layer mask and fill it with pure white. 3---Behind (behind mode): This model is used in a layer within the transparent part of the paint layer; but when the transparent area selected is not available. It can only be used in your paint tool (brush, spray gun, stamp, history brush, paint) or after an object in the layers within the fill command shade or color... 4---Clear (clear mode): This mode is available only when using a fill, paint bucket, and line tool in a hierarchical document. (attached: in the normal layer, the EDIT/CLEAR is filled with transparent areas; in the background layer, EDIT/CLEAR fills the selected part with the background color.) 5---Multiply (positive laminated bottom): This pattern is the highest rate I use. Its extremely useful. It is available in all mixed modes; To understand this, take an analogy. This pattern is like putting two transparent images together on a Zhang Faguang table. Any black part of the original image is black in the result, and any white or removed part of the original image will allow you to see the same part of the other image through it. 6----Screen (screen mode): I