美国西特bs210s型电子天平操作规程（Operation specification for SETRA bs210s electronic balance）.docVIP

美国西特bs210s型电子天平操作规程（Operation specification for SETRA bs210s electronic balance） The United States SETRA SETRA BL-2000S series precision electronic balance Double bond operation is convenient and simple. Weighing and sensing technology using ceramic gold plated capacitor. Standard RS-232 interface, external bar code printer or communication. Overload / impact protection, can withstand 10 times full scale overload. Three options for display speed / output mode. Cast aluminum shell, corrosion protection, anti electromagnetic interference. Plastic sealing dust-proof cover, dustproof and antipollution. Operation regulation of BS210S electronic balance Release date: 2010-12-10 source: Lilac browsing times: 463 Standard operating procedures for type BS210S electronic balances 1. Objective: to establish the standard operation rules of BS210S electronic balance, so as to ensure the correct use of BS210S electronic balance. 2: scope: applicable to BS210S electronic balance operation of all behavior. 3. Responsibility: the central laboratory is responsible for the implementation of the SOP. 4, content 4.1 operation 4.1.1 check if the air bubbles in the level are located in the center of the ring. If not, adjust the height of the anchor bolts so that the air bubbles are in the middle of the ring. If so, you can start the next step on the machine. 4.1.2 boot: switch on the instrument power, press the ON/OFF key balance, after self check, enter the standby state. The 4.1.3 sets the parameters (when needed): take the very unstable code 1.1.4 as an example 4.1.3.1 boot on the electronic balance and hold the TARE key in full screen display, the screen display menu until the first level 1, by repeatedly pressing the CAL key, in the first level menu selection function code 1 ~ 9. 4.1.3.2 press the PTINT key to select the second menu hierarchy, such as 1.1, and also press the CAL button to select another function code on the same menu. 4.1.3.3 then press the PTINT button to select the