cnc控制器（CNC controller）.docVIP

cnc控制器（CNC controller） Jintan Sihai motor and Electrical Appliance Factory cnc controller I. overview CNC programmable controller of stepper motor and stepper motor driver, stepper motor composed of a complete stepper motor control system, can control the stepper motor multi segment operation. The controller uses a computer programming language, with input, output, count, cycle, conditional transfer, unconditional transfer, interrupt and other instructions. Output only on the controller button selection instruction and input parameters to complete the program to control the motor operation and signal and the external input control signal, with programming flexibility, adapt to a wide range of characteristics such as. Two, technical indicators 1. can control 3 stepper motors (any two motors at the same time) 2. can be programmed in 180 stages (different working states) 3.5 speed curve selection 4. highest output frequency: 10 KHz 5.7 inputs, 4 outputs 6. digital display, can show the current running state, the number of 0 ring, pulse number, etc. The 7. common anode connection, +5V output, can directly drive the SH series produced by our factory in step motor driver Three 、 display and operation key of controller 1. panel instructions: 8 digit display: for setting, cycle counting, running state, motor work. The indicator lights show input, output, direction, pulse and other work. The operation keys are mostly compound keys, which represent different functions in different states. 2. wiring instructions: Specific wiring can refer to the following complete process. (1) OPTO, DIR and CP are stepping motor driver control lines, and the three ends are connected to the OPTO, DIR and CP terminals of the drive: Of which: OPTO all drives fold the common yang side Direction level signal of motor No. DIR00 CP00 motor pulse signal Direction level signal of motor No. DIR11 CP11 motor pulse signal Direction level signal of motor No. DIR22 CP22 motor pulse signal (2) start: start t