creo系统参数（Creo system parameters）.docVIP

creo系统参数（Creo system parameters） Flash is used to determine the system parameters ========= quality attributes Mp_mass (path) Used to determine quality Mp_volume (path) Used to determine volume Mp_surf_area (path) Used to determine the surface area Mp_cg_x (path, coord_sys, path) The X coordinate used to determine the center of gravity Mp_cg_y (path, coord_sys, path) The Y coordinate used to determine the center of gravity Mp_cg_z (path, coord_sys, path) The Z coordinate used to determine the center of gravity Pro_unit_mass Sets the default units of quality for all new parts and components (unit_point, unit_ounce, unit_ton, unit_gram, unit_kilogram, unit_tonne) Pro_unit_length Sets the default units of length for all new parts and components (unit_inch, unit_foot, unit_mm, unit_cm, unit_m) Pro_unit_sys Specify default system units for the new model. ============ Water drawing parameters flash system d# The display parameters in the drawing notes, which is the size of the logo #. ad# Display related dimensions in the drawing notes, which is the size of the logo #. rd# Display the reference dimensions in the drawing notes, which is the size of the logo #. p# Shows the number of examples in the drawing notes in the array, the array is # logo. g# Geometric tolerance in the drawing notes, which is # geometric tolerance identification. Displays user defined parameter values in drawing annotations. : att_cmp Target parameter indicating the element parameters associated with the annotation. : att_edge Target parameter indicating the edge parameter associated with the annotation. : att_feat A target parameter that specifies the characteristic parameters to be attached to the annotation. : att_mdl Target parameter indicating the model parameters associated with the annotation. : att_pipe_bend Target parameter, indicating the pipe bend parameters associated with the annotation. : att_spool Target parameter indicating the parameters of the spool associated with the annotation.