凯越ABS灯常亮（Excelle ABS lights lit）.docVIP

凯越ABS灯常亮（Excelle ABS lights lit） The Jetta vehicle ABS warning lamp and brake lights, according to most of the reasons are fault maintenance case control unit, control unit is also the cause of corrosion in the plug connection or loosening some cases 1 reasons, may be due to brake lights before the brakes too thin, brake oil is too small, the parking brake switch failure. The front brake pads, brake oil, brake switch check. 2, ABS light may be due to the ABS wheel sensor problems, fault codes, etc.. ABS wheel sensor can be checked, the use of inspection equipment to extract the fault code and to eliminate the fault code. ABS or EBD is out of order In reply. The handbrake and ABS lamps with light, EBD said there is fault, just read the instructions Take a look at the ABS pump plug is not loose. It should be dropped,.ABS system failure will be two lights at the same time lit Subsystem power allocation (EBD) The system EBD system enables the rear brake to provide a greater proportion of braking force, thereby maximizing the performance of each brake. It works by adjusting the braking force assigned to the rear wheel according to the load condition and speed of the automobile. The EBD system is an integral part of the ABS system and uses some components of the ABS system to perform optimal allocation of braking power. If any of the ABS system components used by the EBD function fail, the EBD system will stop working. When the EBD system is working, you may hear a vibrating noise or feel a slight vibration of the brake pedal, which is normal and not a fault. Take steps - EBD system failure If the EBD system fails, the system will stop working, and the brake system alarm light and the ABS alarm light will be lit simultaneously. The EBD system may malfunction if the brake system alarm light and the ABS alarm light are lit at the same time during driving. Even if the EBD system fails, the conventional braking system will still work. However, when forced to depress the brake