注塑机调试（Injection molding machine debugging）.docVIP

注塑机调试（Injection molding machine debugging） Edit this paragraph structure Injection molding machine based on plasticizing is divided into the plunger type injection molding machine and screw type injection molding machine, press machine and drive mode can be divided into hydraulic, mechanical and hydraulic - mechanical (rod) type, according to the operation mode is divided into automatic, semi-automatic and manual injection molding machine. (1) horizontal injection molding machine: This is the most common type. The die closing part and the injection part are on the same horizontal central line, and the mold is opened in a horizontal direction. The utility model is characterized in that the utility model has the advantages of short body, easy operation and maintenance, low machine center of gravity and stable installation; after the product is pushed out, the utility model can automatically fall down by gravity, and the automatic operation is easy to realize. At present, the injection molding machine is used in the market. (2) vertical injection molding machine: its die parts and injection parts are on the same vertical central line, and the mold is opened in the vertical direction. Therefore, the area is small, easy to place inserts, convenient loading and unloading mould, material hopper into the material can be uniformly plasticized. But after the product is out, it is not easy to fall automatically. It must be removed by hand. It is difficult to realize automatic operation. The machine should be used for small vertical injection molding machine, in general is 60 tons (60 tons refers to the generation of clamping force) is widely used in injection molding machine below, large and medium should be used. (3) angle type injection molding machine: the injection direction and the interface of the die are on the same surface. It is especially suitable for the flat products which are not allowed to leave traces of the sprue in the machining center. It covers an area small