工程绘图教程（Engineering Drawing Course）.docVIP

工程绘图教程（Engineering Drawing Course） This article is contributed by yjq0305 DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Auto CAD 2000 Engineering Drawing Course self-study guide book The design and application of dyeing and finishing engineering class hours: 15 The first chapter is the basic knowledge About Auto CAD 2000 on the computer system configuration requirements, starting method, working interface, master Auto CAD 2000 command input and termination mode and system configuration changes, open storage map, map and other basic command of the operation; understand the basic knowledge of engineering drawing Auto CAD 2000. The second chapter, the use of layers When drawing an engineering drawing, you need to use a variety of colors to distinguish the various lines and functions, and hope to be able to manage separately. The LAYER (layer) command described in this chapter has these capabilities. The third chapter, text style and text note Auto CAD 2000 has a strong word processing capability that allows text to be printed and printed in line with various mapping standards. Auto CAD 2000 provides two ways to write text: single line text and paragraph text. Use Auto CAD drawing engineering drawings, to make the text in line with the mapping standards, you should first set the required text style according to the actual situation. The fourth chapter is the preliminary setting of drawing environment To draw engineering drawings in accordance with the drawing standard, must learn to set the drawing environment needed, then set into the sample. Set the sample includes a lot of content, which will be introduced gradually in the following chapters, this chapter introduces the preliminary set of drawing environment. Sets the drawing environment from the default settings in the startup dialog box to the drawing state. The contents of 8 preliminary settings this chapter i