地板安装（The floor installation）.docVIP

地板安装（The floor installation） How to prepare the wood floor to prepare and the key point of the installation quality of the acceptance floor In the process of decorating, wooden floor is the last process of hard decorate, want in the construction process of early stage Fully and decorates the master to communicate, in the construction before and after the small requirement is to decorate a master to cooperate, can let the wood The floor shows beautiful appearance and satisfactory complete acceptance. The first of the floor installation is the requirement on the ground, the ground is good or bad is the foot feeling that affects the floor most. Therefore, in the process of installation, the following conditions must be satisfied to meet the requirements of the floor quality and ensure that Suitable installation environment. Cement floor should not be dust, it looks dry, moisture content should be less than 2% (the geothermal system should not be more than 1.5%), wood The quality floor should be 6% to 10%; The ground shall be within a radius of 2 meters and must be within the range of 3 mm Quick dry powder for leveling, the ground meets the requirements; The casing of the wires and pipes shall be 5 mm below the cement floor, not exceeding the flatness of the cement floor The floor should be clean and unclutter; The cement floor should be free of cracking and deformation; The second is the requirement for the height of the door. In the installation of the floor of the door commonly have the adornment effect that receives a piece In order to ensure that the door can be opened freely after the floor is installed, the surface of the door and the floor is not less than the floor + floor + 2 mm thickness There are wire and water pipes that should be marked at the door in case of nail damage The third is the height requirement of the foot line. The height of the foot line and the thickness of the floor mat are the position of the foot line The position of wire and water pipes