抹灰工程施工顺序(国外英文资料).docVIP

抹灰工程施工顺序(国外英文资料)Plaster WorkJob requirements:1. structural engineering has been completed, and acceptance by the relevant departments, to meet the standards and play the 500mm line.2. check the door and window before plastering. The location of the hole is correct.3., the basic surface dust, dirt and grease, etc. should be cleaned up, before plastering a day ahead of the wall sprinkling wet.4., all kinds of embedded iron pieces, pipe, ring and so on should be installed in advance, the structural concrete deviation parts should be flattened or repaired in advance.5., the walls of masonry, lack of edges, the corner of the need for hierarchical treatment, water, electric wall, buried pipe, picking groove parts, with special personnel to repair, repairFill when the first rinse water tank float ash, then you will be a building glue brush, followed by cement mortar filling to flat wall.6., internal and external walls of cement mortar, a large area should be done before the model, the owners, supervision units identified, and then organize the construction.7. in the construction of the outer frame should be prepared in advance, they will leave the wall and the corner bar 200~250mm, to facilitate the operation. In order to reduceTo ensure the smooth ash plastering joint, the outer frame should be laid down the three step board, to meet the requirements of construction.8. before plastering, the basic surface shall be checked to determine the thickness of the plastering, and shall be displayed on both sides of the ledge on both sides of the big horn before plasteringThe control line of the ash layer for backing.Technological processThe door and window frame is surrounded by caulking (or vertical and horizontal joints)Impact bar, ash layer, control line, base treatment, floor mortar, elastic line, dividing lattice, sticking, dividing bar, wiping surface and curingA. primary treatment: if the surface is smooth, with its texturing surface is smooth, clean, with a broom throwing