工艺操作制度和安全操作规程(国外英文资料).docVIP

工艺操作制度和安全操作规程(国外英文资料) The process operation system and safety operation procedures, electrolytic safety operation rules 1, work in the electrolytic cell, should stand on the edge of the groove plate or style board, slot cover should first check whether the visit trough cover on the stability, up should be on the cover of bone, are not allowed to take the foot in the crust or electrolyte anode carbon block to work. 2. The tools used for pole changing must be in good condition. Before use, we must understand its function and correct method of use, and fully preheat, and put it in the designated position after use. 3, artificial add raw materials into the tank, must be fully preheated drying, wet raw materials are not allowed to directly into the tank. 4, to replace the anode to effect, should immediately stop the pole change operation, until the effect is extinguished, after the electrolyzer stable, in order to carry out pole change operation. 5, artificial drilling operations, should wear protective masks, grasp force, to prevent the electrolyte splashing burns, such as the slot effect, aluminum and other work should immediately stop work. 6, no matter how hot workplace, do not allow red arm operations, homework must wear good labor protection supplies. 7, in the course of operation, labor protection products on fire should be immediately extinguished or removed, extinguished, can not run around, not to use water pouring. 8, from the groove to remove carbon residue block, we should pay attention to fishing methods, and grasp the direction and strength of efforts, the operation should be taken care of around the staff, in order to prevent injury to others. Check out the anode residue, do not put on the cement floor, should be placed on the residual tray, to burn the cement surface or other accidents. 9. When directing or coordinating the hoisting of objects, the crane shall check that the sling is in good condition and that the bundle is firm and that the personnel ar