DS-7800SH系列海康DDNS设备和装备访问(国外英文资料).docVIP

DS-7800SH系列海康DDNS配置和设备访问(国外英文资料) DS-7800SH series Haikang DDNS configuration and equipment access for models DS-7800SH series network environment through dial-up router mode 1 equipment configuration for the first step DVR the following settings confirm whether all fill project instructions fill DVR IP address settings within the LAN IP address of the router with the same segment as the specific 4 please refer to the configuration of the router must fill out the hard disk video subnet mask set must fill in the hard disk recorder can be set to the default gateway router IP address of the such as the details please refer to the configuration of the router must fill in the preferred DNS and the standby DNS with the corresponding operators to obtain the IP address of the router or fill in the analysis must fill in the second step port the following provides two kinds of exergy mapping The two configuration method to choose a can in 1, UPnP automatic port mapping that this setting has a requirement to the router supports UPnP this function so please confirm your use of the router does it support the function if UPnP can refer to the support set under the support of UPnP if not please in strict accordance with the first step to the operation of port mapping. The operation steps are as follows landing router configuration interface the open UPnP function into the equipment configuration interface enabled UPnP to refresh the local port state display as the effect can be. 2, the router port mapping landing router configuration interface to find the virtual server or port mapping in the exergy exergy equipment 80, the default mapping port 8000, 554 the three ports can be modified the three ports on the device must be indispensable in the mapping if in the same router with multiple monitoring equipment exergy please use port numbers to distinguish between exergy nonreusable port. The third step in configuring custom domain 1, click the right mouse button to quickly configur