FAT 发电机台架试验.pdfVIP

 Wärtsilä  FACTORY ACCEPTANCE TEST FOR Finland Oy WÄRTSILÄ 20 AUXPAC Factory This document is the property of Wärtsilä Finland Oy and shall not be copied, shown or communicated to a third party without the consent of the owner. Subtitle Product Made Page Document No. Rev. 14.02.2007 JaJn/Jakobsson Apprvd FAT Wärtsilä 20 14.02.2007 TJS/Sunngren 1(10) DBAA064499 a Rev Date Made Approve Memo No. Explanation: Exhaust gas temperature mean value a 26.03.2008 ELE010/ JJA006/ Leppäsyrjä Jakobsson Factory Acceptance Test 1 Introduction The test is carried out as an overall check of the manufacturing quality and to establish that the contractual commitments have been fulfilled. The Factory Acceptance Test (FAT) comprises of a running-in part and an official FAT part. The test is carried out in accordance with ISO 15550. The function of built on ancillary systems and the performance of the Wärtsilä 20 Auxpac (in the following “Genset”) is checked according to ISO 15550. Results are recorded in a test report signed by Wärtsilä, customer (if present) and a representative from a classification society. At the end of the factory acceptance test the Genset is inspected by the same representatives mentioned above. After in