无盘 网卡属性设置(详细)(国外英文资料).doc

无盘 网卡属性设置(详细)(国外英文资料) Reduces font size and increases font size Network card property settings (details) Network card property settings Advanced settings for NF NIC Checksum Offload packet verification is recommended to close Flow Control traffic control must be closed IEEE802.1P Support IEEE802.1P supports suggestions for closing Jumbo Frame Payload Size default is 1500, this is gigabit network, a new setting, described in detail below. Low Power State Link Speed card energy-saving proposal closed The modification of Network Address MAC defaults to no. It is not necessary to change it Optimize For CPU/Throughput CPU is optimized for throughput optimization or occupation, set to CPU, the network speed is limited, but the CPU occupancy is low, if changed to Throughput, the performance can fully play the card, but the CPU occupancy will rise a lot. Segmentation Offload recommends closing Speed/Duplex, Settings, Full, Autonegotiation (fully adaptive, usually without modification) VLAN Id defaults to 1 without changing VLAN Support VLAN supports general closing Wake on Magic packet magic data packet wakeup is recommended to close Wake on pattern recommends closing WakeOnLAN From PowerOff recommends closing Advanced settings for 8168/8111c NIC In the advanced options for the network card JUMBO FRAME changed to none 802.1Q/1P VLAN Tagging changed to shutdown Flow Control changed to shutdown Jumbo Frame changed to shutdown Offload Checksum changed to shutdown Offload TCP_LargeSemnd changed to shutdown Advanced settings for 8169/8167 NIC 820.1Q/1p VLAN Tagging=Disable Flow Control=Disable Junbo Frame=Disable Offload Checksum=Disable Offload TCP_LargeSend=Disable Advanced settings for Marvell Yukon card Flow control - disable (or Flow Control-Disable) Transport buffer - 512 (or MaxTransmits-200) Receive buffer - 512 (or MaxReceives-500) Wake up function - Link Change wakeup mode (or WakeUpModeCap_A-28) Uninstall TCP/UDP checksum (IPv4) - disable (or *TCPUDPChecksumOffloadIPv