夏普AR-2820复印机如何调整墨度（国外英文资料）.docVIP

夏普AR-2820复印机如何调整墨度（国外英文资料） 46-2 adjust the automatic copy mode concentration 46-9 adjust the concentration of copy mode 46-10 adjust the pattern concentration of text photo 46-11 adjust the photocopy mode concentration I changed my body with sharp AR2718 copiers, load and cartridges, all stores to buy original), copy is to compare light, want to make the manual is only black, but for some data copies made the base of color is black, how to adjust to the end of the tone light, font copy the thick? Please tell me more about the kind man The first thing you need to do is go into maintenance mode: # insert C insert Sim46-1 exposure intensity adjustment When the mode is executed, start preheating and display the current manually set upper limit (ME) on the copy number display To select display, click the magnification factor to display the key Reprints are shown on the screen The data is displayed in position 1, 2, 3 A 1 -- 99 manual (ME) upper limit B 1 -- 99 manual (M) lower limit C 1-99 manual (ME) toner saves the upper limit The d-1 - -99 manual (ME) toner saves the limit E 1-99 (PE) limit F 1-99 (PE) below the limit G 1-99 automatic (AE) tilt H one minus 99 automatic (AE) values I 1 - -99 automatic (AE) color saves the tilt J 1-99 automatic (AE) color powder saves the lower limit The range is 1 - -99, while decreasing the value increases the number of the corresponding values when the bottom is gray. When finished, press the CA key to cancel the adjustment (note) for automatic (AE) tilt and automatic (AE) color, you must set 0. First you go into maintenance mode: # insert C insert And then on the 46-01, the machine is going to be about 50 or so if your machine reads 60 then youre going to change 55 to OK The sharp AR2820 copiers maintenance code Update time: 2010.09.04:1571 Often occurs in: (1) F5 fault code, the first optical part of the whole line machine cleaning, the cause is the cause of local dirty optical parts, the white level gauge board has a stain. The c