网络设备和主机syslog配置方法（国外英文资料）.docVIP

网络设备和主机syslog配置方法（国外英文资料） SNMP and Syslog configuration reference for Cisco network devices Set the IOS devices In the Enable state of IOS, knock in Config terminal enters the global configuration status Cdp run enable Cdp SNMP - server community gsunion ro configures the read-only string of this router for gsunion SNMP - server community gsunion rw configures the read-write string of this router for gsunion SNMP - server enable traps allows the router to send all types of SNMP traps SNMP - server host IP - address - server traps trapcomm specifies that the recipient of the router SNMP Trap is 7, using trapcomm as a string when sending traps The SNMP -server trap-source loopback0 takes the IP address of the loopback interface as the source address of the SNMP trap Logging on starting log mechanism Logging IP - address - server sends the log records to the syslog server on 7 (the IP address of the CW2K installation machine) Logging facility local7 defines the event type as local7 Logging trap warning defines the record event severity level as starting from warningl, all the way up to the most urgent level of events that record the syslog server specified in the previous side. The logging source-interface loopback0 specifies the IP address that the source address of the record event is loopback0 The service timestamp log datetime sends a record event containing the time tag Enable password * * * * * Line 4 tty 0 Password * * * * * Login local sets the Enable password and the Telnet password The show running Copy running start or write terminal displays and checks the configuration Save the configuration Set the CatOS equipment At the Enable state of the CatOS, knock in The set interface sc0 VLAN ID IP address configures the local administrative interface for the VLAN ID, IP address, subnet mask Set CDP enable all enables CDP The set SNMP community read-only gsunion configures the read-only string of the switch to public The set SNMP community read-write-all gsunion co