电气装备考验平安办法(国外英文资料).docVIP

电气设备检修安全措施(国外英文资料) In order to ensure the safety of normal production and electrical maintenance personnel, the following operation safety procedures are developed by the electrical equipment operator. To strictly implement the provisions of the electric part of the coal mine safety regulations. All mechanical and electrical workers must undergo strict technical training and safety training. The electromechanical workers shall carry the good electrical tools and instruments with them, and the voltage level shall meet the requirements. Before each shift, you must listen carefully to the first class report on the operation of each equipment, and understand the status of all the equipment in the work area. 5, repair electrical equipment must be worn when insulation protection appliance, strictly follow the system stop sending, stop sending to have someone whos in charge, the access switch control equipment, this switch to power outages and hung someone work, are not allowed to send brand, and have the modes, strictly enforce the regulations for the underground stop sending. Only within the scope of around 20 meters of gas concentration is lower than 1%, is allowed to open the electrical equipment, and the same grade pencil to test after cut off the electricity, after confirmed, discharge, and then to conduct a comprehensive maintenance, after maintenance is correct, either. It is strictly forbidden to move, disconnect, remove and repair electrical equipment and lines. 7, all the cables are not allowed to have open joint, crevasse, leakage phenomenon, cable in the event of breach, should be adopted and vulcanizing has the same effectiveness of cold patch, are allowed to send. 8, all electrical equipment it is forbidden to open operation, electrical equipment maintenance, the explosion-proof surface shall be properly protected, shall not be smashed, and ensure the explosion-proof surface finish and explosion-proof performance, and the anti-rust oil or petroleum jelly to