电动模型制作的准备任务及电念头的制作1(国外英文资料).docVIP

电动模型制作的准备工作及电动机的制作1(国外英文资料) The electric model makes the preparation and the electric motor make 1. Its not that you dont laugh. People are not smart, and they learn to be bald. Dont say my heart doesnt hold my heart! No, no, no, no, no, no, no, no! Be happy when you are alive, because we will die long. Please dont speak English in front of me, OK? The preparation of the electric model and the production of the motor First job The production model should have the appropriate design and the necessary tools and materials. The seven models required for this book are based on the following: Thin iron - a can of iron can be opened for use, but there is no rust on the iron: because rusty tin is not easily solder. Enameled wire - an electric motor in an electric model requires a lacquered wire with a diameter of 0.1 to 0.13 mm, preferably 0.1 mm in diameter. In addition, as the wiring of the motor connection, the diameter is 0.3 ~ 0.5 mm. Thin copper - motor brush and commutator, all need to use copper, but very few requirements, can be removed from the bad with copper, the thickness of 0.3-0.5 mm, it is best to brass. Large block paper - the shell of the model, a large part of which is to be made out of large block paper in the form of a clay, can be found in the block paper that has been written. Thin wood - some model boats are made of thin wood, so the model is lightweight. You can use a wood chip with a thickness of 0, 6-1 mm, which can be bought in the aviation model store, and the same thickness of pine. Quick-drying glue -- this is what makes models often. When make myself, but in banana oil (scientific name isoamyl acetate, can buy in the paint shop, the original as dilute with spray paint) put (i.e., nitrocellulose), celluloid transferred to general glue consistency can be used. When making a model, use this kind of quick-drying glue to apply to the boat, and the water-repellency ratio is good, and it is strong. Celluloid -- nitrocellulose, in some parts of the