11G101-1板教材(国外英文资料).doc

11G101-1板讲义(国外英文资料) It should be marked in brackets, where there is a high difference, and there is no indication. The negative digit in brackets is below the level of the floor and the positive number is higher than the level of the floor. In situ of the beams, the main indication of the negative reinforcement and the radiation arrangement and the measurement and location of the spacing. No girder block 11G101P96 concentrated mark No girders shall be labeled in the center: The general use of the non-girder floor is the form of plate belt: 1, the number plate with ZSB representative column upper belt (on the top of the column), KZS said across the plate with (arrangement in the middle of the plate across, I here is not without pillars. 2, the span of the strap and the suspension of both ends of the suspension Band H = XXX. The width of the board band? And the longitudinal hamstring that is going through the longitudinal tendon is going to be the top of the top of the B, which is going to be the same thing as the top of the bar, and if you have the same thing in the upper and lower bars, you can also say BT. No beam floor board in situ label: The main label is non-penetrating and the length of the straddle across the length of the non-penetrating line. 2, in the flat beam floor there is a ALP97 this is AL of plate, should pay attention to is not in the beam AL here both have obvious difference, plate with AL ought to be focused on marking and labeling in situ two forms, 1) the AL central label should be labeled A, the number of AL (P43 6.4.3-.3), the span of AL and whether there is a suspension, B, the section size of AL, the outer leather width of the hoop is thick C, AL stirrup The upper part of the AL is usually a tendon or a tendon 2) AL in situ annotation Mark the upper and lower longitudinal of AL supportsFolded plate Yang Angle and internal Angle of its structure is the same way, and on the outside of the steel in the fold points are straight through, the ins