技能提升培训班课件 - edf法国电力 workshop pt gis and cable rev 3.1 - cn.pdfVIP

WORKSHOP ON POWER TRANSFORMER, GAS INSULATED SWITCHGEAR AND UNDER GROUND CABLE Loïc Popiel Shi Peile EDF- Beijing 法电北京 Presentation 内容提纲 Introduction介绍 Chap 1- Power Transformer Manufacturing 主变工厂监造 Chap 2 - Power transformer testing 主变出厂试验 Chap 3 - Gas Insulated Switchgear manufacturing 气体绝缘封闭组合电器GIS工厂监造 Chap 4 – Gas Insulated Switchgear testing GIS出厂试验 Chap 5 - Under Ground cable Manufacturing 电缆工厂监造 Chap 6 – Underground Cable testing 电缆出厂试验 1- INTRODUCTION 介绍 A- Objective of the workshop 培训目标  To give an introduction on factory inspection for power transformer, Gas Insulated Switchgear and under ground cable. 通过讲解 ，了解主变、GIS 、高压电缆的工厂监造要点和出厂试验项目内容及标准。 Voltage range from 50kV to 500kV 电压范围5万至50万伏特 Based on EDF’s own experience, international practices (IEC and CIGRE) and Chinese standards (GB). 根据法国电力公司的经验、国际惯例 （IEC和 国际大电网会议 ）以及中国国标GB For each electrical equipment, the workshop will provide guidance for 对于每种设备 ，本次培训都将提供讲解和指导 ，以便 ： Carrying out inspection during manufacturing 工厂监造阶段开展检查 Carrying out inspection during factory testing 出厂试验阶段开展检查  3 1- INTRODUCTION 介绍 B- Organization 培训计划  Total duration总时长 : ½ day 半天  Time schedule 日程规划: 14h00 – 14h45 : key control during manufacturing and testing of Transformer 主变设备工厂监造和出厂试验要点 14h45 – 15h00: 15 mn Break 休息 15h00– 15h30 : key control during manufacturing and testing of GIS ，GIS 设备工厂监造和出厂试验要点 15h30 – 15h45: 15 mn Break 休息 15h45– 16h15 : key control during manufacturing and testing of UG cable 电缆设备工厂监造和出厂试验要点 16h15 – 16h30: 15 mn Break 休息 16h30– 17h00 :Questions 提问和回答时间 CHAPTER 1 KEY CONTROL POINTS DURING POWER TRANS