电气工程质量薄弱环节的预防措施.docVIP

电气工程质量薄弱环节的预防措施 电气工程质量薄弱环节的预防措施提要：暗配管路弯曲过多，敷设管路时，应按设计图纸要求及现场情况，沿最近的路线敷设，不绕行，弯曲处可明显减少 其它精品 电气工程质量薄弱环节的预防措施 1变压器一、二次引线，螺栓不紧、压按不牢。母线与变压器连接间隙不符合规范要求。提高质量意识，加强自检互检，母线与变压器连接时锉平。 2线槽盖板接口不严，缝隙过大并有错台。操作时应仔细地将盖板接口对好，避免有错台。 3小容量电机接电源线时不摇测绝缘电阻。应做好技术交底，提高摇测绝缘的必要性认识，加强安装人员的责任心。 4暗配管路弯曲过多，敷设管路时，应按设计图纸要求及现场情况，沿最近的路线敷设，不绕行，弯曲处可明显减少。 5剔注盒、箱出现空隙、收口不好，应在固定盒、箱时，其周围灌满灰浆，盒、箱口及时收好后再穿线上器具。 6预留管口的位置不准确。配管时未按设计图要求，找出轴线尺寸位置，造成定位不准。应根据设计图要求进行修复。 7暗配管路堵塞，配管后及时扫管，发现堵管及时修复。配管后及时加管堵把管口堵严实。 8管口不平齐有毛刺，断管后未及时铣口，应用锉把管口锉平齐，去掉毛刺再配管。 9沿桥架或线槽敷设的电缆防止弯曲半径不够。在桥架或线槽施工时，施工人员考虑满足该桥架或线槽上敷设的最大截面电缆的弯曲半径的要求。 10防止电缆标志牌挂装不整齐，或有遗漏。应有专人复查。 11线路的绝缘电阻值偏低。管路内可能进水或者绝缘层受损都将造成线路的绝缘电阻值偏低。应将管路中的泥水及时清干净或更换导线。 其它精品 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent