水、电安装工程安全措施.docVIP

水、电安装工程安全措施 水、电安装工程安全措施提要：放电缆时，电缆终端应绑孔牢固，线盘应转动缓慢，防止脱杠或倾倒，电缆敷设至拐弯处，应站在外侧操作 更多资源来 水、电安装工程安全措施 1、多台配电箱并列安装时，手指不得放在两盘的接合处，也不得触摸连接螺孔。 2、剔槽打眼时锤头不得松动，楼板、砖墙打眼透眼时、板下墙后不得靠近。 3、人力弯管器弯管时、防止滑倒和坠落、操作时头部要避开。 4、管子穿带线时，不得对管口呼唤、吹气，防止带线弹力勾眼，穿导线时互相配合防止挤手。 5、放电缆时，电缆终端应绑孔牢固，线盘应转动缓慢，防止脱杠或倾倒，电缆敷设至拐弯处，应站在外侧操作，木盘上的钉子应拨掉或打弯。 6、进行耐压试压试验装置的金属外壳必须接地，被测设备或电缆两端应有人看守，人员撤离，并检查无误后方可开压。 7、用摇表测定绝缘电阻时，应防止有人触及正在测试中线路和设备，测定感性或容性的设备，材料（如变压器、电缆等）必须放电，雷电时禁止测定线路绝缘。 8、电流互感器禁止开路，电压互感器禁止短路和以开压方式运行。 9、电焊机外壳必须接良好，焊钳与把线必须绝缘良好连接牢固，更换焊条应戴手套，更换场地时必须切断电源，并不得手持把线爬梯凳高，雷电时，禁止露天焊接作业，焊接过程中应注意防火。 10、井道内作业时，必须设置牢固的盖板、防护栏杆，安全网或其它防坠落的保护措施。 11、攀登作业时、梯底部应坚实，示得垫高使用、梯子上端须有牢固措施，踏板上下以30mm为宜、并应有防滑措施。 12、施工人员须遵守工地各项规章制度。 13、每次施工后应做到工完场清。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. Th