BAL--EDrumbodyspiral-divideddesign-ongearu.docVIP

Operating Instructions Reel body, spiral, divided design - on gear unit K20.BAL7100-0007-E Page  SEITE 20 of  ANZSEITEN 20 Reel types ES 25.., ES 31.., ES 20.. / D 6500 mm on gear unit K20.  C O N T E N T S Page  VERZEICHNIS \o 1-2 1 General information  SEITENREF _To\h 2 2 Drum body components  SEITENREF _To\h 2 3 Assembly of the reel body  SEITENREF _To\h 4 3.1 Requirements  SEITENREF _To\h 4 3.2 Assembly of the reel wheel  SEITENREF _To\h 6 3.3 Assembly of the reel wheel to the gear unit  SEITENREF _To\h 13 3.4 First alignment of the reel (without cable)  SEITENREF _To\h 14 3.5 Ramp  SEITENREF _To\h 16 3.6 Angle for cable insertion  SEITENREF _To\h 18 4 Placing the cable on the drum and connecting up  SEITENREF _To\h 18 4.1 For the preparatory work prior to placing on the drum  SEITENREF _To\h 18 4.2 Preparation of the cable end and leading to the slip ring body  SEITENREF _To\h 19 4.3 Placing cable on drum  SEITENREF _To\h 19 4.4 Reeling the cable  SEITENREF _To\h 20 4.5 Connecting up the cable  SEITENREF _To\h 20 5 Check the drum width and adjust if required  SEITENREF _To\h 20   General information The function of the reel body is to take up a reeling cable (high voltage, low voltage or control cable). As a standard the reel body has the capacity to take up the wound-up length required for this operation plus 2 windings for tension relief. Note: All below numbers in brackets ( ) refer to the corresponding positions on figure 1 to figure 3. Reel body components The reel body is delivered dismounted and is composed of: - 9 resp. 10 premounted reel segments  - 1 ramp - 2 reel plates - 1 angle for cable guidance - 1 box with screws, nuts, washers and lock nuts  Assembly of the reel body Requirements The assembly of the reel body - requi