9-27断油稳燃调试程序介绍.doc

印度尼西亚龙湾3×315MW燃煤电厂工程PLTU 3 BANTEN（3×315MW） Project 调 试 程 序Commissioning Procedure PT.PLN (PERSERRO) Owner’s File No. 0703-00-M-01-H-002 PT REKADAYA ELEKTRIKA PT.PLN(PERSERRO) JASA SERTIFIKASI(LMK) CONSORTIUM OF DONGFANG ELECTRIC CORPORATION AND DALLE ENERGY 四川电力调试所 SiChuan Electric Power Commissioning Test Institute 印度尼西亚龙湾3×315MW燃煤电厂工程 PLTU 3 BANTEN (3×315MW) Project 批准 Approval 日期 Date 调试程序 审核 Review 日期 Date 校核 Check Z日期 Date 号 No. SCCTI-TS-GL-CS-003-2009A 版本号 REV 0 目 录Table of Contents 1. 调试目的 Purpose 3 2. 调试范围 Scope 3 3. 编制依据 Preparation Basis 3 4. 系统及设备简介 Brief Description of System and Equipment 3 5. 调试所需工具、仪器 Tools and Instrument for Commissioning 7 6. 调试应具备的条件 Prerequisite for Commissioning 7 7. 调试程序 Commissioning Procedure 9 8. 安全措施 Safety Measures 11 9 附录 Appendix 13 9.1 附录1 调试条件检查确认表Appendix 1 Commissioning Condition Checklist 14 9.2 附录2试运参数记录表Appendix 2 FTrial Run Parameters Record 16 1. 调试目的Purpose 在锅炉带负荷启动调试过程中实现稳燃、安全断油，可节约燃油，提高机组运行经济性。Stable combustion and safe fuel oil cut-off reached in the process of commissioning for boiler start-up with load can save fuel oil and increase economic operation of units. 2. 调试范围Scope 本程序适用于锅炉断油低负荷稳燃调试，包括锅炉主保护的检查确认、断油前的燃烧调整、断油试验、断油后的燃烧调整。This Procedure is applicable to the commissioning of low load stable combustion after boiler fuel oil cut-off, including check and verification of boiler protection, combustion setting before fuel oil cut-off, fuel oil cut-off test and combustion setting after fuel oil cut-off. 3. 编制依据Preparation Basis 3.1 印度尼西亚龙湾3×315MW燃煤电厂机组整套启动试运调试大纲Startup and commissioning plans for PLTU 3 BANTEN (3×315MW) Power Plant 3.2 印度尼西亚龙湾3×315MW燃煤电厂机组工程资料Engineering documents associated with PLTU 3 BANTEN (3×315MW) Project （1）烟风系统及煤粉系统图DRGs of flue-gas and air system and pulverized coal system （2）锅炉性能与结构说明书Manual of boiler performance and structure （3）燃烧设备说明书Manual of combustion equipment （4）磨煤机使用说明书Manual of coal mill operation 4. 系统及设备简介Brief Description of