压力容器工程规定.docxVIP

压力容器工程规定Engineering Specification for Pressure VesselsC O N T E N T S目录1. GENERAL概述1.1 Scope范围1.2 Codes, Standards and Regulations规范、标准及规章1.3 Units单位1.4 Purchaser’s Drawing and Documents买方图纸及文件1.5 Vendor’s Drawings and Documents卖方图纸及文件1.6 Site Condition现场条件2. DESIGN设计2.1 Design Pressure设计压力2.2 Design Temperature设计温度2.3 Corrosion Allowances腐蚀余度2.4 Materials材料2.5 Loading Conditions and Strength Calculation负荷条件及强度计算2.6 Tolerances允许偏差3. DETAIL DESIGN详细设计3.1 Shells and Heads容器壁及顶3.2 Internals内件3.3 Nozzles and Manholes设备口及人孔3.4 Bolts, Nuts and Gaskets螺栓、螺母及垫片3.5 Supports支架3.6 Miscellaneous其它4. FABRICATION制作4.1 Plate Layout排板4.2 Forming成型4.3 Welding焊接4.4 Heat Treatment热处理5. INSPECTION AND TESTS检测及试验6. NAMEPLATE, PAINTING AND MARKING铭牌、刷漆及标识6.1 Nameplate铭牌6.2 Painting刷漆6.3 Marking标识7. PACKING AND SHIPPING包装和运输7.1 General概述7.2 Packing and Preparation for Shipping包装与运输准备7.3 Shipping运输Appendix A: Tolerance for Pressure Vessels附A：压力容器允许偏差1. GENERAL 概述1.1 Scope 范围1.1.1This specification together with the engineering drawings covers the requirements for the materials, design, fabrication, inspection, testing and supply of pressure vessels used for CIBA SBR 3rd line project inZhenjiang, the People’s Republic of China.本规范及工程图纸包含对中国镇江CIBA SBR第3条线工程中使用的压力容器的材料、设计、制作、检测、试验及供应的要求。This specification shall be referred to also for the non-pressure vessels except for the requirements of local regulation if vessel shape is similar to pressure vessels.本规范也可用于外形与压力容器相同的非压力容器。1.1.2The definition of pressure vessels shall be in accordance with “Supervision Regulationon Safety Technology for Stationary Pressure Vessels” in the People’s Republic of China.压力容器的限定根据中国的“固定式压力容器安全技术监察规程”进行。1.1.3This specification does not apply, in general, to auxiliary pressure vessels which are attached to turbines, engines, pumps, compressors and other mechanical equipment which are normally designed under the manufacturer’s standard.一般情况下，本规范不适用于涡轮、发动机、泵、压缩机及其它依照厂家标准设计制造的机械设备的附属压力容器。1.2 Codes, Standards and Regul