templte to model the way in the set.docVIP

template to model the way in the set, through inspection qualified rear can implement the whole project, and ensure the quality of the whole project in line with the requirements of process standards. 6.2.2.5 concrete engineering quality assurance measures 5-1 concrete strictly in accordance with the requirements of the concrete construction specifications; Once completed for continuous casting. 5-2 before pouring, measures must be formulated strict pouring and pouring route, and detailed technical clarificaiton. 5-3 concrete mixing of raw material must be strictly controlled, and control the temperature, and ensure the temperature loss in transit within the prescribed scope. 5-4 before pouring into the mould temperature of concrete, concrete layer continuous casting, casting the strictly control layer, each layer height is not more than 40 cm, to avoid the time is too long to produce construction cold joint. 5 - to control the generation of cracks and make full use of the later strength of concrete, reduce the dosage of cement in concrete, preventing the early cracking of concrete; In roof concrete used in construction, the second of plastering construction process of concrete early crack. 5-6 contact the meteorological department in advance before concrete pouring, query, as far as possible to avoid cold weather pouring concrete, especially the rain and snow weather, in case of rain and snow is a moratorium on the casting, and to have completed the construction and implicit inspection qualified face in striped cloth covers, prevent the rain and snow into the structure template, affect the quality of concrete. 5 to 7 after concrete pouring, the heat preservation, moisture curing of concrete, slow cooling, give full play to the creep of concrete, reduce the temperature stress. 5-8 side walls should formulate detailed technical measures, to prevent the run mode. 6.2.2.6 foundation drainage measures 6.2.2.6.1 precipitation scheme Before construction seriously understa