使用说明书2详解.doc

3.3 Command Format 3.3命令格式 When entering commands, remember that: 当输入命令时，请记住： ? A carriage return (CR) ends each command. ?回车（CR）两端各命令。 ? Values in square brackets are optional. 在方括号?值是可选的。 ? The camera will answer each command with either a carriage return CR and line ?相机会回答每个命令与一个回车cr和线 feed LF followed by OK or Error x: Error Message . The is always the 喂“行”或“错误*：错误信息”。“”始终是 last character sent by the camera. 最后一个字符发送的相机。 ? The following parameter conventions are used: ?使用以下参数约定： t = tap number 吨=抽头数 i = integer value 我=整数值 f = real number =实数 s = string 的=字符串 [ ] = optional parameter [ ] =可选参数 3.4 Startup 3.4启动 When the camera is first started, it must perform several actions before it is ready for 当相机是第一次启动时，它必须执行几个动作之前，它是准备 imaging. This startup routine takes approximately 15 seconds, and follows this sequence: 影像学。这个启动程序大约需要15秒，并遵循这个顺序： 1. Initializes the camera and all internal hardware. 1。初始化相机和所有内部硬件。 2. Loads the last settings saved to non-volatile memory. 2。加载保存到非易失性存储器的最后一个设置。 3. Restores user settings if previously saved, otherwise factory settings. 3。如果先前保存的话，恢复用户设置，否则为工厂设置。 4. Performs a memory test and voltage test and reports an error if any occurred. 4。进行记忆测试和电压测试，并报告错误，如果发生任何。 After this startup sequence has completed, the camera will return either the prompt 启动序列完成后，相机将返回提示 OK if no error occurred, or an error code if a problem has been discovered. “确定”如果没有错误，或错误代码，如果已经发现了问题。 3.5 Saving and Restoring Settings 3.5保存和恢复设置 The camera provides a number of commands for restoring, storing, and saving settings. 该相机提供了一系列的命令，用于恢复，存储和保存设置。 ? To restore the original factory settings, use the command rfs. ?恢复原厂设置，使用命令RFS。 ? To save all current user settings to EEROM, use the command wus. The camera will ?保存所有当前用户设置的EEROM，使用命令WUS。相机将 automatically restore the saved user settings when powered up. 自动恢复保存的用户设置时，供电。 ? To restore the last saved user settings, use the command rus. ?恢复上次保存的用户设置，使用命令罗斯。 3.6 Setting Baud Rate3.6 设置传输速率 To set the speed of the ca