外文翻译-栏板起重装置的结构与设计.docVIP

附录 Steeplechase lifting device structure and design Lifting Gear steeplechase and design of the structure of the lifting mechanism is relatively traditional, the tail plate lifting mechanism using only a single fuel tank, so that the hydraulic system of the pipe is simple, convenient control and high reliability of the hydraulic system, and and ease of installation. The above analysis and calculation of the institutions such as the structure and properties of the mathematical relationship between parameters. To promote inter-related with the sleeve of the friction and wear, the sleeve guide groove angle and flip angle and a high degree of adaptability, such as lifting will be subject to further research and the analysis of the structure of hair. Lifting Gear steeplechase vehicle movements in foreign countries as the rear door (end plate), its installed in the car named after the tail. In this paper, according to national standards call a lifting gear steeplechase. Steeplechase a lifting device installed on the van in the carriage of goods, not only to demonstrate its proprietary water-resistant dust-proof function, but also in the loading and unloading of goods mechanization achieved. 1 steeplechase development Lifting Gear Lifting Gear steeplechase development, largely in foreign countries can be divided into four periods. The first generation of products in the 30s at the end of this century, characterized mainly lifting cylinder, and the steeplechase manually turned on, from or about the quality of 500kg, steeplechase (also known as loading platforms) touchdown angle 9 ° ~ 10 °. At present, this product in South-East Asia, Japan still in use, 90 years, is still the United States by the new development. Second-generation products in the early 50s the European market, in the first generation of products based on the increase of turnover to close the fuel tank. Lift and flip the fuel tank by two to achieve independence. The most common is a type 4 tank, but also of