吹风机风罩塑料模具设计论文.docVIP

吹风机风罩塑料模具设计 摘 要 本次设计主要内容包括制品工艺分析，成型方法及工艺流程制定，模具类型和结构等形式确定，成型工艺条件确定，工艺计算（即注射量、注射压力、锁模力、导向与定位机构设计、脱模机构设计、加热与冷却系统设计、绘制模具装配图、编写设计说明书等。） 以上各工序模具的设计在满足加工精度的基础上充分考虑节约成本因素，确定了成型工艺工序；紧接着通过熟悉各类模具的加工特点及内部结构，完成模具总体结构的分析；随后进行毛坯尺寸、注射压力、锁模力、导向与定位机构设计、脱模机构设计、加热与冷却系统设计、绘制模具装配。在此基础上确定模具的外形，最后完成了装配图和非标准的零件图以及确定压力机类型及主要参数。 关键词：吹风机风罩， 浇注系统， 脱模机构， 塑模装配图 Caliper stamping die design ABSTRACT This design is rectangular blank volume into a circular hoop with a 1 mm gap. This article on the basis of a reasonable analysis of caliper stamping process, determine the forming of clamp needed to complete the final two die of parts. First design of the die to die, to complete the volume required to round rectangle of blank, from the product parts diagram to see the final forming part of the structure is simple and is a symmetric graph, blanking sections only need to ensure the blank dimension; second series of die design of bending and rolling die, to complete the final shaping, to ensure the clearance of 1 mm. Above the process die of design in meet processing precision of Foundation Shang full consider savings cost factors, determine has card hoop stamping parts most optimization of rushed Conference processing process; immediately by familiar various die of processing features and the internal structure, completed die overall structure of analysis; then for stock size, and row sample, and process size, and stamping pressure, and stamping Center, and die work part size, technology calculation, this Foundation Shang determine die of shape, last completed has Assembly figure and non-standard of parts figure and determine pressure machine type and the main parameter. KEY WORDS: plait， in-line， reciprocaningiscrew， trip slide assembling die 目　录 前 言 5 塑料模具毕业设计分析 6 一：毕业设计的目的 6 二：模具设计的内容 6 1、设计内容 6 三、模具设计的步骤与方法 7 四、模具设计的要求 7 （4） 设计说明书： 8 五、 设计课题 8 吹风机风罩塑件如图1—1所示 9 第1章 塑件工艺分析 10 1.1.1力学性能： 11 1.1.3环境性能： 11 1.1.4 ABS塑料的加工性能 11 1.2 注塑工艺规程编制 12 1.2.1 注塑工艺过程概述 12 1.2.2 型腔数目的确定 15 1.2.3 塑件体积