EMERSON艾默生 Quick Start Guide Rosemount Wireless ET410 Corrosion Transmitter说明书用户手册.pdf

Quick Start Guide MS-00825-0100-4209, Rev AA April 2023 ™ Rosemount Wireless ET410 Corrosion Transmitter ™ with Rosemount Permasense technology Quick Start Guide April 2023 Safety messages Failure to follow these installation guidelines could result in death or serious injury. Only qualified personnel should perform the installation.  WARNING Explosion hazard that could result in death or serious injury. Installation of this transmitter in an explosive environment must be in accordance with the appropriate local, national, and international standards, codes, and practices. Review the approvals section of this manual for any restrictions associated with a safe installation. Before connecting a CC21 to a sensor, ensure the correct low voltage permits have been obtained The power module may be replaced in a hazardous area. Only fit Permasense or Rosemount approved BP20E power modules. Magnetic hazard that can result in death or serious injury This device contains magnets which could be harmful to pacemaker wearers. The strong magnets used in the magnetic fixture can lead to serious hand injuries unless personnel are careful. Electrostatic hazard that can result in death or serious injury The power module has surface resistivity greater than one gigaohm and must be properly installed on the wireless device. Care must be taken during transportation to and from the point of installation to prevent a potential electrostatic charging hazard. The transmitter’