(1.2.1)--1.2.2Preparingthedressform(PPT)产品效果图表现技法.pdf

Foundation of draping for fashion design 1.2.1 Preparing the dress form PREPARING THE DRESS FORM Side seam/shoulder alignment: Place a plastic ruler at the side seam and the center of the plate screw. Do the seams align with a ruler? If not, mark and draw a new side seam. Waist line：Replace the waistline tape if not smooth. Bust Bridge：A panel is fixed between the apex and extends to the side seam, and fixed with a needle. Note that this panel must be parallel to the side waist line. Additional points: fix one stitch at the end of the shoulder, and also at the midpoint of the armhole. Fix one stitch 1cm down the center front. Armhole depth: Choose an armhole depth according to different clothing sizes. Place tape at the shoulder tip, over the screw to the side seam to get the measurement and secure a pin. Stylelines: On the form, you can use a needle or tapes to indicate the style line. Measuring the Dress Form 1. Bust/back level: Place tape over chest and full back, parallel to the floor. 2. Waistline: Measure around waistline. 3. Hip level: Measure around the widest part of the hip, parallel to the floor. 4. Side length 5. Shoulder length 6. Bust depth 7. Center front/back length 8. Full length 9. Front bust 10. Back bust 11. Front/Back waist 12. Front/ Back hip 13. Hip depth