Dell戴尔Dell Precision Tower 5810 7810 7910 1700MT 1700SFF 3620MT and Rack 7910 Thunderbolt Add-In-Cards Setup Guide 说明书 用户手册.pdf

Dell Precision Tower 5810/7810/7910/1700MT/1700SFF/3620MT and Rack 7910 Thunderbolt Add-In-Cards Setup Guide Setting up the Thunderbolt Add-In-Card This section describes in brief on how to install the thunderbolt add-in-cards on a Dell Precision Tower 5810, 7810, 7910, Rack 7910, T1700 MT, T1700 SFF and 3620 MT. Pre-requisite actions before setting up a Thunderbolt card: 1. To utilize a Thunderbolt Add-In-Card (AIC) make sure you have a compatible Thunderbolt system board. 2. Install Thunderbolt software before installing the Add-In-Card (AIC). NOTE: Thunderbolt card supports windows operating system only. Linux operating system is not supported. To setup a Thunderbolt Add-In-Card 1. Connect the GPIO cable to the GPIO header on the system board. NOTE: There is a 5-Pin keyed GPIO cable, one end goes to the card, and the other end goes to the GPIO header on the system board. • For Precision Tower 7910: the Thunderbolt AIC is placed in CPU1 slot 3 • For Precision Tower 5810/T7810: the Thunderbolt AIC is placed in CPU1 slot 5 • For Precision Rack 7910: the Thunderbolt AIC NOT supported • For Precision T1700 MT: the Thunderbolt AIC is placed in slot 4 • For Precision T1700 SFF: the Thunderbolt AIC is placed in slot 1 • For Precision T3620 MT: the Thunderbolt add in card (AIC) is placed in slot 3 2 Setting up the Thunderbolt Add-In-Card 2. Connect the display port to DisplayPort cable. Finding More Information and Resources See the safety and regulatory documents that shipped with your computer and the regulatory compliance website at / regulatory_compliance for more information on: • Safety best practices • Regulatory certification • Ergonomics See D for additional information on: • Warranty • Terms and Conditions (U.S. only) • End User License Agreement Additional information on your product is available at /suppo