电气类毕业论文外文翻译5.docVIP

英文原文： Using Watch Window Here are brief instructions for using the Watch Window in conjunction with ServLink to view and tune the variables for your 733. These instructions are meant to be intro -ductory. Full on-line help is available in each application. It is assumed that you al -ready have ServLink and Watch Window installed. The default installation location can be found by clicking the START icon (Microsoft Windows 95 or later) on the main menu bar and then clicking the PROGRAMS menu item. Look for an icon called WOODWARD WATCH WINDOW. 1. Make sure that all other programs that may access your computer communications port are shut down and you know the communication port connected to the control. 2. Start the ServLink server and open a new file. Select the proper COM port for your PC, verify that POINT TO POINT communications mode is selected, and verify that the baud rate matches the baud rate of the 733 control. See the on-line help file if you have been changing the port settings of your control. 3. Select OK. If everything is working right, you should see an animated picture of a string of “1”s and “0”s flying from the control to the PC on your screen. You now have a network definition file whose default name is NET1. You should save this file as “your ” (use FILE/SAVE AS). Link this name to your control part number since it will work only with that application. For instance, if the upper level control number is 8273-040, you could save the file as .NET. Do not disconnect the server. 4. In the ServLink window you will now have another dialog window titled “your ”. In this window you will see a ballhead icon and a control identifier name. Unless you have given the control a serial number (or name) with the SLSN.EXE program, this name will display as “unidentified”. 5. Start the Watch Window application. When Watch executes, you will have a screen displaying three windows entitled Watch Window, Explorer, and Inspector. 6. The Explorer window will have two gro