国外K5+TS3PASS(付K5解法) CCIE RAMP;S.docVIP

TS3:1. SLA ticket, wrong source IP, made it work but still got a few errors.2. BGP ticket, R12 was missing next-hop-self for R5.3. Multilink ticket, wrong hostname on chap authentication.4. IPv6 ticket, tunnel was missing ospfv3 configuration on both sides.5. DNS ticket, SW4 had an ACL blocking the ping to PC42.6. FR QoS ticket, 2 faults, CIR changed to 100k to match bandwidth and class-map didnt have service policy configured.7. Multicast ticket, surprisingly this was very easy, just had to change IPs for MSDP peering.8. Internet ticket, 2 faults, removed summary-only on R2 and advertise PCs network on SW1.9. MPLS ticket, 2 faults, R7 and R6 Loopbacks need to advertise in OSPF process and remove area range on R4 messing up LSP.10. MST ticket, change port-priority on SW5.K5Section 1 Layer 2 (21 points)1.1 Initial Faults Spanning-tree bpdufilter enabled on trunk ports.?no spanning-tree bpdufilter enable Switchport protected on SW(X)’s fa0/10.?no switchport protected Score: 4 points.1.2 Implement Access Switch Ports of Switched NetworkConfigure all of the appropriate non-trunking switch ports on SW1-SW4 according to the following requirements: VTP domain should be “CCIE” and password “cisco”. VTPv2 should be configured with SW1 as server. SW2, SW3, SW4 VLAN database should be updated by SW1. Configure the VLAN ID and Name according to the table below (case sensitive). Configure the access ports for each VLAN as per the diagram. All 4 switches must run in transparent mode after synchronization. All unused ports including Giga ports have to be on access VLAN 999 and shutdown. Score: 3 points.VLAN_ID NAME16 VLAN_16_R1toSW118 VLAN_18_R1toSW328 VLAN_28_R2toSW336 VLAN_36_R3toSW145 VLAN_45_R4toR568 VLAN_68_SW1toSW369 VLAN_69_SW1toSW489 VLAN_89_SW3toSW4100 VLAN_100_BB1200 VLAN_200_BB2300 VLAN_300_BB3500 VLAN_500_Client999 Unused_PortsSW1:vlan 16name VLAN_16_R1toSW1vlan 18name VLAN_18_R1toSW3vlan 28name VLAN_28_R2toSW3vlan 36name VLAN_36_