XT2000i维修程序.pptVIP

Service program XT-2000i Service Program XT-2000i XT-2000i Service Program Service Program 维修程序总览 Service Program CP-Test Sequence(穿刺单元测试程序) Initial position adjustment(初始位置调整) Front position adjustment(向前位置调整) Up position adjustment(向上位置调整) Rotate position adjustment(旋转位置调整) Clamp/ Pierce adjustment(夹紧/穿刺调整) 当执行上述程序之一后,错误会恢复 Service Program CP-Test Sequence(穿刺单元测试程序) Service Program Sampler Test(进样器测试) 5个程序 2 half steps left ( Rackbarcode)(向左两个半步-条码调整) 1 full step right (Sensor adjustment)(向右一步-传感器调整) 1 full step left (Sensor adjustment) )(向左一步-传感器调整) Left and right (Sensor adjustment) )(左右一步-传感器调整) 当执行上述程序之一后,错误会恢复 Service Program Sampler Test (进样器测试) Service Program Rinse Cup Sequence(清洗杯程序) 测试和调整清洗杯 当执行上述程序之一后,错误会恢复 2步程序 Service Program SRV Test Sequence(旋转阀程序) 旋转并检查SRV 用于调整SRV 在UP和DOWN两个位置用细针调整SRV的正确位置 Service Program Mixing Motor Test Sequence(混匀马达测试程序) 检查马达功能 打开程序可以使马达工作 点击OK 按钮停止马达工作 Service Program Diaphragm Pump Test(隔膜泵测试) 所有的隔膜泵同时工作 Service Program Laser Power(激光功率) 打开激光 显示激光功率 点击程序打开激光 点击 OK按钮退出 Service Program Clog Level adjustment(堵孔水平调整) 靶值是: 100 +/-2 Service Program Service Setting(维修设定) Service Program Special Mode(特殊模式) Normal Analyse: 用于检测新鲜血 Control 3: 工程师调整灵敏度时使用e-Check 重要:工程师做好e-Check后,一定要将模式改为NORMAL Control 1: For SF-Check measurement Control 2: For RET-Check measurement Latex: Only for R/D Calibrator 1: For SCS 1000 Calibrator 2: For SCS SF-Check Calibrator 3: For RET II-Check To enter into Continuous Mode Service Program Special Mode Service Program Service Sequence(维修程序) For Optical alignment (rough and fine) (激光调整-粗调和细调) For Shipping(用于运输前排空) For Detergent (清洗) To measure the Power consumption(目前不用) For Setting Sequence(装机时灌注试剂) Service Program Service Sequence(维修程序) Service Program Service Sequence(维修程序) Optical alignment rough(激光调整粗调-60秒) Service Program Service Sequence(维修程序) Optical alignment (fine) (激光调整粗调-20秒) Service Program Service Sequence(维修程序) Shipping Sequence with(运输前程序)需要 蒸馏水 蒸馏水和乙醇(