组装说明书AssemblyInstructionofDemonstrationKitofOdorControl.PDFVIP

“气味控制设备演演示套件” 组装说明书 Assembly Instruction of Demonstration Kit of Odor Control Equipment 此系统仅供用于演示之用，它设计成可装在卡车后面的拖车套管上，中国的拖车套管可能与美国不一样，但可找 一个套筒装在卡车后即可。注意，整个套件是到达演示目的地后再组装起来的，一旦装好，车子就不能在路上路 动，因为，它的设计强度没考虑这一点。This system is only for demonstration use and it was designed to be attached on the hitch for its support point. Attention, after the system is assembly, the truck cannot be driven on road. It should be assembly on the site where you want to do the demonstration. 1 “总系统支座” 的组装Assembly of “Hitch Support Bracket” of the system 这就是“总系统支座” This is 假设这是卡车后面的拖 “总系统支座”插入“套 the “Hitch Support Bracket” 车套管，用于支撑“总系 管” 内后用螺杆拴住。 for support misting head 统支座” This is “Hitch The “bracket” is inserted and whole bracket system. Support” that could be into the hitch support and on back of truck or other lock with a bolt 2 “绞盘支撑杆” 的组装Assembly of “Winch Support Bracket” “绞盘支撑杆” 上有绞盘，用来拉起整个雾炮头到一定的高度. “Winch Support Bracket” has a winch to raise the whole misting head system. “绞盘支撑杆”被插入“总系统支 “绞盘支撑杆”被插好后用螺杆拴住。 座”后端的孔内。“Winch Support “Winch Support Bracket” is locked Bracket” is inserted into the hole with a bolt. of “Hitch Support Bracket” 3 两节 “雾头支撑托杆” 的组装Assembly of two pieces of “Atomizer Support Brackets” 这是第一节“雾头支撑托杆” ，注意，有挂钓环 用螺杆把 第一节“雾头支撑托杆” 栓住在“总系统支 的边朝上 This first piece of “Atomizer Support 座”上 The “Atomizer Support Brackets” is fixed on the Brackets” and the hook should be upside “Hitch Support Bracket” by using a blot. 这是第二节“雾头支撑托杆” This second piece 把第二节“雾头支撑托