PlannedLines 2002(计划测线).ppt

Planned Lines计划测线 Planned Line Files计划测线文件 Planned Line Format计划测线格式 Creating Planned Lines创建计划测线 Creating Planned Lines - Methods创建计划测线-方法 Line Editor Tour 测线编辑器向导 Manual X-Y Entry - Example手动 X-Y 输入-举例 Manual Entry – Enter Your Coordinates手动输入-键入你的坐标值 Manual Entry – Preview the Initial Line手动输入- 预览初始化的计划测线 Manual Entry – Setting a Curve手动输入-设置一段曲线 Manual Entry – Creating Offsets手动输入-创建偏移的航迹线 Manual Entry – The Finale!手动输入-结束曲 Planned Lines - Offset Methods计划测线-偏移方式 Offset Types - Centerline偏移类型-中心线偏移 Offset Types - Parallel偏移类型-平行线 Offset Type - Radial偏移类型-放射线 Offset Types - Search偏移类型-发散线 Offset Types – Stair Step偏移类型-阶梯步进 Planned Lines – Cursor Method计划测线-光标法 Using the Cursor to Set Waypoints使用光标来设置航迹点 Using the Cursor – Con’t使用光标-继续 Entering Waypoints in Lat - Long以经纬度的形式输入航迹点 Clipping Planned Lines剪切计划测线 Clipping Planned Lines剪切计划测线 Clipping Planned Lines – Part II测线剪切-第二部分 Clipping Planned Lines – Part III测线剪切-第三部分 Importing Lines from DXF Files从DXF文件输入测线 DXF to LNW - Background从DXF到计划测线-背景 DXF to LNW - Details从DXF到计划测线-详细资料 DXF to LNW Details – Part IIDXF到计划测线细节-第二部分 DXF to LNW - Results从DXF到计划测线-结果 Channel Design航道设计 CHANNEL DESIGN - Basics航道设计-基础 CHANNEL DESIGN – Entering Data航道设计-输入数据 CHANNEL DESIGN - Chainage航道设计-起始里程 CHANNEL DESIGN - Previewing航道设计-预览 CHANNEL DESIGN - Parameters航道设计-参数 CHANNEL DESIGN – Smart Corners航道设计- 聪明转角 CHANNEL DESIGN – Lines at Turns航道设计-拐角加线 CHANNEL DESIGN – Lines at Beginning/End航道设计-测线的始端和终端 The CHANNEL DESIGN routine allows you to generate planned lines and their cross-section templates by entering details about the Left Toe, Centerline and Right Toe lines. 该程序能够允许你通过输入航道的left toe,centerline 和right toe的数据来产生计划测线和他们的横断面模板. Start by entering the number of points in each element (e.g. Number of left toe points = 8). 在每一个单元格内输入点数(例如,left toe为8点) Enter the X-Y position for each point, along with the depth of the channel at that point. 根据沿着航道上的点的深度来输入每一点的x-y位置数据. For Toe Lines, enter the slid