p550物理视图.docVIP

Subscribe to this information POWER5 information Locations — model 55x and OpenPower 720 Use this information to help you map a location code to a position on the server for the 9133-55A, 9406-550, 9113-550, and OpenPower? 720 models. Note: The known logical location codes for this unit are listed next to the corresponding physical location in the following information. If you are working with a logical location code for this unit and it is not listed in the following information, contact your next level of support. The following diagrams show field replaceable unit (FRU) layout in the system. Use these diagrams with the following tables. If you need address information, refer to Addresses – model 55x and OpenPower 720. Figure 1. Front view of the system Figure 2. Back view of the system with 2 RIO/HSL ports on the planar and 1 bus card slot. Bus card is installed, port 1 is C6-T1 (closest to board) and port 0 is C6-T2 (towards the top of the card). Figure 3. Back view of the stand-alone system with 2 RIO/HSL ports on the planar and 1 bus card slot. Bus card is installed, port 1 is C6-T1 (closest to board) and port 0 is C6-T2 (towards the top of the card). Figure 4. Back view of the system with no RIO/HSL ports on the planar, but has 2 bus card slots (C6 and C14). When bus card is installed port 1 is Cx-T1 (closest to board) and port 0 is Cx-T2 (towards the top of the card). Figure 5. Back view of the stand-alone system with no RIO/HSL ports on the planar, but has 2 bus card slots (C6 and C14). When bus card is installed port 1 is Cx-T1 (closest to board) and port 0 is Cx-T2 (towards the top of the card). Figure 6. Top view of the system (including service processor reset switch) Figure 7. Memory module locations on the processor card The following table provides location codes for parts that make up the server. Attention: After replacing any part on a server or expansion unit, perform Verifying the repair. Table 1. FRU locations and failing components Failing it