OSSIM编译方法.docVIP

OSSIM Build Instructions Version 1.3 3 July 2010 RadiantBlue Technologies, Inc. 516 East New Haven Ave. Melbourne, FL 32901 Table of Contents 1 Introduction 2 1.1 Obtaining the source 2 1.2 Standard Environment Variables 3 1.3 Modules and their dependencies 4 1.4 Compile variables 4 2 Compiling the libraries 6 2.1 Building on Unix Flavor Systems Including MACs 7 2.2 Building on Windows 8 2.3 Find Package Trouble Shooting 8 3 How to Add Your Own Libraries to the Build 9 4 Preference file setup 9 4.1.1 Plugin keyword setup 10 4.1.2 Elevation keyword setup 10 4.1.3 Geoid setup 11 5 Verify the Installation 11 6 Work Still To Do 12 Introduction This document describes the latest build procedures for the entire OSSIM distribution. The cmake build system is now supported with OSSIM starting at version 1.8.6 and will be the primary mechanism for building platform specific IDEs and builds. We are using cmake version 2.8.1 which can be found at /. Cmake version 2.8.1 is used for qt4 macro support and for Framework build support on MAC’s if you are not using these modules then cmake version 2.6.X should be sufficient. This document describes the build process for the OSSIM distribution using cmake. Obtaining the source The build system supports user customizable locations. For this example we will use ~/ossim-svn . The ossim library modules are currently hosted at and can be obtained by doing an svn checkout: svn co /ossim/trunk . The included example follows a build on Mac OSX and is a very similar build to other unix based systems. Open a terminal window and enter the following: cd mkdir ossim-svn cd ossim-svn svn co /ossim/trunk src This example creates a subdirectory on disk called ossim-svn and then checks everything out there. Your ossim-svn subdirectory should have the modules ossim, ossimPlanet, ossim_qt, libwms, … etc. Standard Environment Variables OSSIM build instructions will assume the following 3 environment variables are defined: OSSIM_DEV_HOME OSSIM_I