- 1、本文档共11页,可阅读全部内容。
- 2、有哪些信誉好的足球投注网站(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
IICL MODEL TEST 2 试卷
IICL MODEL TEST 2 (120 Minutes)
Please choose only one correct answer among a, b, c, d of every question and tick it.
The procedures described in the repair manual for steel containers should be ____.
I. strictly carried out by the repairer II.deviated from as needed
III. Supplemented as necessary. IIII. followed with the methods suggested by the owners.
A,I,IIII. B.II.III C.II.III.IIII. D.all of above
2. The purpose of any repair is to ____.
A. make the ctn. Water tight. B. enable the ctn. to withstand expansive impact.
C. restore ctn.’s structural integrity. D. make the ctn. carried by ship.
3. The method selected should be ____.
A. the most simple one. B. the most economical and can meet the purpose of the repair.
C. a complicated one. D. including the modern technique.
4.How many hinges does every door have to hold it in place?
A.one,two or three. B.two, three or four. C. three, four or five. D.four,five or six.
5. In the case of leased ctrs, on which the damage and wear are to be noted?
A.on the EIR B.on the owner’s approved form
C.both all right D.none of them
6. Considering the replacement quality, if the criginal material has special chemical properties, it can be substituted by____.
7. Which of the following main categories of defects are used in the Guide For Container Equipment Inspection?
A.deterioration, contamination and abrasion.
B. deterioration, damage and wear.
C. deterioration, contamination and damage.
D.damage, wear and non-conforming repair.
8. Which of the following kind is not belong to the types of damage?
(1)bends,bowing,breads,burns.
(2) contamination due to infestation, stains, or objectionable odor.
(3) dents, dimensions beyond ISO tolerances.
(4) holes or pin-holes.
(5) corrosion of metal components not due to contact with foreign substances.
A. (1) only. B. (3) only C. (1) (2) D. (5) only
9.Which of the following general rules are usually applied in the inspection of conta
文档评论(0)